Step 1 — First login & change password

1. Open a browser and enter the sensor's IP address.

2. Select Admin profile (full access) or Reader profile (read-only) from the dropdown.

3. Default password: password — change this immediately to a strong password following your company's security policy.

4. The wizard starts automatically on first login.

Step 2 — Region

Set the country and measurement units (metric or imperial). This affects how mounting height is entered and how tracking bubbles are displayed. Enable Xovis Product Improvement to help Xovis improve detection algorithms — recommended.

Step 3 — Date and time

Configure NTP time synchronisation. Xovis strongly recommends using the default NTP pool (pool.ntp.org). Do not use a local Microsoft timeserver — it is not compatible. All sensors in a multisensor must be synced to the same NTP server.

Step 4 — Network identification

Configure DHCP or static IP. If switching from DHCP to fixed IP, the sensor will immediately come up on the new address — update your browser URL accordingly. Set the sensor Name (e.g. "TR – Maslak Enza Entrance") and Group (e.g. "TR"). These appear in Xovis HUB Device Control.

Step 5 — Mounting height & tilt

Enter the exact mounting height (floor to sensor front panel). Accuracy must be within ±5cm — incorrect height causes miscounts.

PC-Series: Measure with a laser distance meter. Enter the height and overwrite current tilt by clicking ▼ → Save.

PF-Series: Automatic height detection using a measurement point. By default the point is at the centre of the sensor's view. Adjust only if needed — the point must be entirely on the floor and ideally perpendicular below the sensor.

Step 6 — Image setup (PC-Series only)

Three masks are configurable. The floor mask is mandatory.

Step 7 — Recalibration (PC-Series only)

After drawing the floor mask or changing the mounting height, apply the new recalibration. A recalibration is required whenever:

• The floor mask has been redrawn

• Mounting height has changed

• Sensor tilt has changed by ≥1° in X or Y axis

Click Apply recalibration to activate. Check the stereo image — the floor should appear as a homogeneous blue area.

Step 8 — Privacy level

After the wizard

Once all steps are complete, click Finish wizard. You are redirected to the sensor overview. Next steps:

1. Configure counting lines and zones in Scene Configuration (see Xovis — counting line & zone placement)

2. Activate the HUB Device Control connection to Vemcount in Settings → Remote connections

3. Add the sensor MAC address in Vemcount Settings → Devices