What you need before starting

• VS133-P powered and connected to a network with internet access

• Firmware v133.1.0.8 or later (check in System → Device Info)

• Outbound TCP 443 allowed to data.vemcount.com

• Login access to Vemcount (Admin role)

Step 1 — Configure HTTP data push on the sensor

1. Log in to the VS133-P web interface (enter the sensor's IP address in your browser).

2. Go to Communicate → Data Push Settings.

3. Click + Add and fill in:

1. Click Save.

2. Refresh the page — if the status shows green (Connected), the push is working.

Step 2 — Get the MAC address

1. In the VS133-P interface, go to System → Device Info.

2. Copy the MAC Address.

Step 3 — Set up company structure in Vemcount

Create or navigate to the Company, Location, and Installation Zone where this sensor will be placed (same as any other sensor setup).

Step 4 — Register VS133-P in Vemcount

1. Go to ⚙ Settings → Devices → + Add sensor.

2. Fill in:

1. Leave all other fields blank.

2. Click Submit.

Step 5 — Verify live data

Wait 1–2 minutes. Check the Installation Zone — people counts should start arriving. If not, confirm the HTTP push status is green on the sensor and that TCP 443 outbound to data.vemcount.com is not blocked by your firewall.